GenieH2O

Category

Brochure: Click HereĀ 
Manual: Click Here
The GenieH2O is designed to supply hot water. The heating element structure is designed for permanent work under water pressure up to 0.65 MPa. Any pressure tap battery therefore can be fitted to the heater. The water supply system can be connected using flexible rubber hoses and gaskets. The traditional mechanical power switching mechanism has been eliminated to miniaturize and improve the reliability of the heater.

ENQUIRE NOW

Description

Pressurized flow-through water heater GenieH2O is designed for instant delivery of warm water to the GreaseShieldĀ®. For economical use of the heater, it should be installed as close as possible to the GreaseShieldĀ®. This appliance is designed to be used in a moist environment. However, splashing with water is prohibited. Maximum delivered water temperature should not exceed 30ĀŗC.

The GenieH2O requires its own independent power source, separate from the GreaseShieldĀ®. A 20 amp fuse spare is required to power the Genie H2O.

One should remember that heater output depends on:

  • Its electric power.
  • Water stream flowing through the appliance. The bigger the flow, the lower the water temperature on exit (table 1);
  • Voltage drop in electrical system. For instance: a voltage drop of 10% results in a lowering heating output by 19% (table 2). Voltage drop below 185V causes blockage by electronic.

Table 1. Supplied water temperature 15ĀŗC

 

 

 

 

 

 

Table 2. Heater power depending on voltage in electric system

 

 

 

 

 

 

System possibility of appliance switching on;

  • Ā Supplied water temperature.

CAUTION!
It is strictly forbidden to assembly, disconnect and incline the heater on sides while power is switched on.

 

 

 

 

 

 

 

The device can only work in position showed on drawing below. Trying to start the device in position other than proper one will result in damaging a heating element and the guarantee being null and void.

Safety Regulations

Heater can be installed by authorized person only.

  • Ā Heater must permanently be connected to electrical system equipped with earthing
    connector and differential switch.
  • Heater can work in position showed on drawing 1 only.
  • Never exchange earthing wire with live wire.
  • Heater can only work using perfectly working safety devices.
  • Heater must not be installed in rooms where temperature drops below 0ĀŗC.
  • Heater should not be installed in aggressive or subject of explosion environment.
  • Heater can only be used when is in perfect technical condition.
  • In case of heaterā€™s defect immediately cut off water and power supply.
  • All service and maintenance works can be completed only with power switched off
    4.
  • Only original spare parts can be used for repair
  • Casing should never be disassembled while power is on
  • Avoid electronic system to be splashed with water
  • In case of heaterā€™s defect or improper work switch off power and shut off water supply
    using stopping ā€“ suppressing valve.
  • Water tap drain tube sprinkler (strainer) should be cleaned regularly.
  • Power supply system should be periodically checked up (voltage drops), particularly
    electrical connections.
  • Water flow should be suppressed in such way to avoid excessive temperature (take
    care of children).
  • This appliance is not intended for use by persons (including children) with reduced
    physical, sensory or mental capabilities, or lack of experience and knowledge, unless
    they have been given supervision or instruction concerning use of the appliance by a
    person responsible for their safety.
  • Children should be supervised to ensure that they do not play with the appliance.